Fetch Better Yielding Results with These Steps
The performance of your planter is what you can control. Although it's just an equipment, the very thing that you need more these days – yield, happens to have huge influence.
Both government, as well as private industry research, has shown the impact a worn and misadjusted planter has on the output. Differing seed spacing, depth and pressure on yield were evaluated on 12 fields of agricultural research across the Midwest by white engineers and agronomists. They also found out the importance of cultivator gauge wheel in the yielding process.
Seed Meter
Regardless of the seed meter type (finger pickup or pneumatic), you want to disassemble all the parts with compressed air completely to clean them.
Researcher says that in the process, you probably need to use a spray surface solvent. The removal of graphite and seed coverings adhering to the meter surface often does not allow for the easy removing of water and soap.
After purification, look for wear and tear in all working parts of the meter. Use the owner's manual as a guide to your planter.
Cultivators replace automatic parts such as brows, straps and their idlers when it comes to finger pick-up meters every year. Look for a squatted wear box or lift box to determine if it is to be replaced. Buff any rust, which may on metal surfaces have developed. Watch the façade of the meter in order to look for wear during your examination.
Check for worn paddles or cracks on seed conveyor belts. You want to make the belts smooth. Check your drive holes to see if you've lengthened the pulley.
The most challenging problem with pneumatic meters is to remove seed from plastic parts.
Components of pneumatic meters requiring special wear care:
Screens. They are essential to keep a precise vacuum.
Disks of meter. You wear much more than you know.
Pins. Every year they should be substituted.
Lids and housing. It can be heat warping.
The Row Units
Then concentrate on the rowing units and mainly wear and tear them. Start with every attachment at the front of the unit and end with packaging wheels.
As attachments are often overlooked, since they have been added to the planter. In order to determine whether they have been damaged during last year, at least check their frames and assemblies. If the blades have been used a lot, they must probably be sharpened (if designed as such).
Inspect double disc openers with disc removal and diameter measurement. Replace the discs, if the measurement is near or above 1⁄2 cm less than the original size.
The Rest Planter
Now take a while to look at the rest of the planter with your inspection of the row. Take note of the overall driving system, hydraulic tubes, electrical cabling and connections and tires, and their operating conditions and performance.
Get Cultivator Gauge Wheel from 4AG Manufacturing in Oklahoma. This can give you better yielding results.